Artec handheld laser metrology
Artec Point & Point II Reflective Targets
Find 3 mm and 6 mm positioning markers for Artec Point metrology scanning modes.
Quick answer: The original Artec Point manual specifies 6 mm retro-reflective markers for blue-light fast scanning and 3 mm markers for fine scanning. Point II is also a target-based system, but its software and target-size settings should be checked independently.
Use the model-specific reference table below for details. A matching marker diameter does not by itself certify scanner compatibility.
Shop recommended reference targets
Choose a size and format, then follow the product link for current prices and availability. These are genuine Messpunkte product photographs; the selected product variant determines the final size and adhesive.
6 mm reflective roll
4,000 standard-adhesive reference dots for compatible 6 mm fast scanning.
6 mm standard sheets
2,000 reference dots for standard sheet-based application.
3 mm reflective sheets
Smaller positioning dots used for the original Point fine scanning mode.
3 mm reflective roll
4,000-dot roll for repeated compatible small-marker scanning.
Which format is right for my application?
The user manual lists 6 mm reflective markers for blue-light fast scanning.
The manual lists 3 mm reflective markers for fine scanning.
Confirm its current software settings; do not assume every original Point target rule carries over.
For 6 mm jobs, light adhesive or magnetic markers may be useful when supported.
Scanner models and target compatibility
| Scanner / mode | Marker specification | Selected product |
|---|---|---|
| Original Artec Point, fast scan | 6 mm retro-reflective | 6 mm sheets |
| Original Artec Point, fine scan | 3 mm retro-reflective | 3 mm sheets |
| Artec Point II | Check model-specific recognition | Confirm with scanner software |
Follow the exact scanner and measurement-mode specification; where manufacturer-supported compatibility has not been established, suggestions are presented as starting points.
Reusable and specialty reference targets
Alternatives to reapplying adhesive markers on every scan, subject to your scanner's recognition and mounting requirements.
6 mm magnetic reflective dots
Reusable magnetic markers for compatible steel surfaces. Keep each marker rigidly positioned throughout the scan.
6 mm glueless markers
210 marker pack for temporary placement, using the exact glueless Messpunkte variant photograph.
Reusable target strips
40 strips for convenient positioning. Reference markers are purchased separately.
Magnetic hex reference bases
Multi-face magnetic bases; size L supports up to 8 mm dots. Request the required configuration and lead time.
Do you need scanning spray, too?
Reference markers support positioning and scan alignment. ATTBLIME matting spray helps capture optically challenging surfaces. Keep markers clear of overspray so the scanner can recognize them.
Frequently asked questions
Can Artec Point use 3 mm markers?
Yes. The original Point manual lists 3 mm references for fine scanning mode and 6 mm for fast mode.
Does Point II use exactly the same targets?
Point II is target-based, but confirm its current recognition settings and user manual instead of assuming all original Point specifications apply.
Why does size vary by mode?
Different optical scanning modes and working distances affect target recognition; smaller dots can help with small geometry.
Do I need spray if using dots?
Not always. Dots support positioning; matting spray addresses difficult surface finishes.
Are Messpunkte dots Artec OEM?
No. They're aftermarket reference markers and must be verified for optical compatibility.
Technical references and support
Original Artec Point user manual · Target selection guide · How to apply marker dots · Compatibility guide · All Messpunkte targets
Not sure about target diameter, surface finish or scanner software mode? Ask 3D Scanner Supply before ordering.
Technical review: November 2026. Scanner names identify potential applications only. Messpunkte reference markers are independent aftermarket consumables; a matching nominal size alone does not guarantee optical compatibility.
