Creaform optical tracking
MetraSCAN & C-Track Reflective Targets
Understand when 12 mm positioning references are appropriate for Creaform optical tracking and photogrammetry.
Quick answer: For Creaform C-Track or photogrammetry workflows that require 12 mm retro-reflective reference markers, choose Messpunkte 12 mm standard or light-adhesive targets. We also offer compatible magnetic hex reference holders by custom order. Verify the target requirement for your measurement mode before ordering.
Some newer tracking configurations do not require on-part reference dots. This page focuses on 12 mm workflows that do.
12 mm targets and reusable hex bases
Two choices for applicable C-Track marker-based workflows: 12 mm retro-reflective positioning targets, or custom-order reference holders. Confirm your system's target specification before ordering.
12 mm reflective targets
800 high-reflectivity reference markers per pack. Choose standard adhesive or the light adhesive alternative for suitable sensitive surfaces.
Magnetic hex target bases
Reusable multi-face holders for a 12 mm positioning-reference layout. Confirm mounting, suitable base size and lead time. Reference markers are sold separately.
Choose your 12 mm adhesive
12 mm standard sheets for regular reference layouts on appropriate surfaces.
12 mm light sheets for easier removal from compatible finished surfaces.
MetraSCAN / C-Track compatibility
Use these 12 mm reference markers only where the tracker or photogrammetry setup calls for them. Verify target type and diameter against your C-Track configuration.
| Setup | Reference guidance | Recommended action |
|---|---|---|
| C-Track reference workflow requiring markers | 12 mm retro-reflective positioning dots if specified | Choose 12 mm standard or light |
| Large-volume optical reference alignment | Confirm required marker diameter before changing targets | Shop 12 mm reference targets |
| Reusable hex reference holders | Sized to the 12 mm target; custom order | Request a quote |
Do you need scanning spray, too?
Reference markers support positioning and scan alignment. ATTBLIME matting spray helps capture optically challenging surfaces. Keep markers clear of overspray so the scanner can recognize them.
Frequently asked questions
Does every MetraSCAN require 12 mm targets?
No. It depends on the external C-Track, photogrammetry and scanning modes; some current configurations are target-free.
How do I confirm that my C-Track setup needs 12 mm reference markers?
Check the target specification for your C-Track generation and photogrammetry configuration, or compare the diameter and optical properties of your existing markers. Contact us with the model and mode if uncertain.
Can I use light adhesive?
Yes when your system calls for 12 mm markers and easier removal is appropriate for the part finish.
Do you offer reusable 12 mm target holders?
Multi-face fixtures are custom order. Confirm geometry, magnetic mounting and dot diameter before quoting.
What details should I send?
Send MetraSCAN model, C-Track generation, tracking mode and current reference-dot specifications.
Technical references and support
Target selection guide · How to apply marker dots · Compatibility guide · All Messpunkte targets
Not sure about target diameter, surface finish or scanner software mode? Ask 3D Scanner Supply before ordering.
Technical review: November 2026. Scanner names identify potential applications only. Messpunkte reference markers are independent aftermarket consumables; a matching nominal size alone does not guarantee optical compatibility.
