SCANTECH handheld metrology
SCANTECH KSCAN & SIMSCAN Target Dots
Find retro-reflective reference markers for compatible SCANTECH marker-based laser scanning setups.
Quick answer: 6 mm reference markers are a common starting point for KSCAN workflows. SIMSCAN recognition can differ by generation and operating mode, so do not assume it uses 6 mm without checking your current markers or software settings. TrackScan and NimbleTrack employ different tracking arrangements.
Use the model-specific reference table below for details. A matching marker diameter does not by itself certify scanner compatibility.
Shop recommended reference targets
Choose a size and format, then follow the product link for current prices and availability. These are genuine Messpunkte product photographs; the selected product variant determines the final size and adhesive.
6 mm reflective roll
4,000 standard-adhesive dots for high-volume marker-based scanning.
6 mm reflective sheets
Standard sheets; light and strong adhesives are available on the product listing.
3 mm reflective dots
For smaller geometry only when your exact scanner recognizes 3 mm markers.
6 mm magnetic dots
For ferrous parts when the scanner recognizes the magnetic reference target.
Which format is right for my application?
Match the markers supplied with your exact SIMSCAN model, rather than relying on a brand-wide rule.
Compare 6 mm sheets and 4,000-dot rolls.
TrackScan and NimbleTrack can use optical tracking that differs from on-part dot placement.
Scanner models and target compatibility
| Scanner family | Starting point | Caution |
|---|---|---|
| KSCAN handheld series | Often 6 mm reflective | Confirm model-specific recognition |
| SIMSCAN series | Verify exact target diameter | Do not assume 6 mm across versions |
| TrackScan / NimbleTrack | Externally tracked configurations | On-part targets may be unnecessary |
Follow the exact scanner and measurement-mode specification; where manufacturer-supported compatibility has not been established, suggestions are presented as starting points.
Reusable and specialty reference targets
Alternatives to reapplying adhesive markers on every scan, subject to your scanner's recognition and mounting requirements.
6 mm magnetic reflective dots
Reusable magnetic markers for compatible steel surfaces. Keep each marker rigidly positioned throughout the scan.
6 mm glueless markers
210 marker pack for temporary placement, using the exact glueless Messpunkte variant photograph.
Reusable target strips
40 strips for convenient positioning. Reference markers are purchased separately.
Magnetic hex reference bases
Multi-face magnetic bases; size L supports up to 8 mm dots. Request the required configuration and lead time.
Do you need scanning spray, too?
Reference markers support positioning and scan alignment. ATTBLIME matting spray helps capture optically challenging surfaces. Keep markers clear of overspray so the scanner can recognize them.
Frequently asked questions
Does every SCANTECH scanner use 6 mm target dots?
No. SCANTECH produces several scanner and tracking families. Check the exact model and selected scan mode.
Is 3 mm supported on SIMSCAN?
This needs confirmation for the specific SIMSCAN model and software version. Do not substitute smaller dots based on generic guidance.
What is the advantage of a target roll?
The 4,000-dot roll offers lower unit cost for frequent compatible target-based scanning.
When should I use magnetic markers?
On suitable ferrous parts when the scanner recognizes the markers and their position will remain stable.
What do I send to check compatibility?
Send the full scanner model, existing dot diameter or photo and software alignment mode to 3D Scanner Supply.
Technical references and support
Target selection guide · How to apply marker dots · Compatibility guide · All Messpunkte targets
Not sure about target diameter, surface finish or scanner software mode? Ask 3D Scanner Supply before ordering.
Technical review: November 2026. Scanner names identify potential applications only. Messpunkte reference markers are independent aftermarket consumables; a matching nominal size alone does not guarantee optical compatibility.
